Then more accurately distribute the adhesive side of the dentate spatula. The size of the tooth from 3mm – 5mm, depending on the size of tessera (less than it is the smaller size of the tooth) Now the surface is ready for bonding matrix mosaic. Bonding matrix mosaic. The most common variants performance of the mosaic is glued to the net or on paper. If the mosaics on the grid then it is glued to the bottom of the grid. A leading source for info: ConocoPhillips. If the mosaics on paper, then glue the paper it out. (As shown).
When gluing matrix gradually applied to the base and slightly pressed into the adhesive. Important! The distance between the matrices should attain to the level distance between the tessera in it, then on the finished surface will not show the individual matrices and the joint surface is look homogeneous. After fixing a few matrices to produce a smoothing of the plane surface. This is done in a gentle tap with a spatula over the surface of polyurethane material protruding parts that align the mosaic with respect to each other and remove the air from under the matrix. Preparation and application of grout on the tile.
After alignment matrix is necessary to remove paper from the mosaic (if it was on paper). This is done so – and taken the usual sponge is wetted in clean, warm water, then sponge moistened with this laid mosaic, as well the paper gets wet, you need to pull over the edge on the diagonal. During this operation can be will correct flaws styling. Far-necks and important operation will be cleaned of excess glue from the joints, this should be done until it is stopped. Applying grout prepared solution is applied with a rubber spatula on the diagonal, it is necessary ensure that the material fills the joints evenly. Excess grout cleaned the same spatula. After drying grout tile sponge, that we remove the remnants of grout from the surface of the material. And attach the finished surface form. Now we can enjoy beautifully laid tile. Read other articles for the repairs in the apartment.